Design & Purchase: Bases
Cast Aluminum Standard Fixture Base

Rib Construction

6" - 14" wide bases	16" wide & up bases

Wolverine's Standard Fixture Bases are a stock item that can be ordered in numerous sizes to suit your requirements.

The "H" dimension shown on bases will be held within .125. If the nominal "H" dimension is to be held to size, the additional cost for this service will be quoted.

If bases are ordered in pairs, the height will be held to +/- .002 in relationship to each other at no extra charge.

Machined Tolerances
(Applies only to horizontal position)

+/- .0005" per foot not to excede .005" over-all squareness relationship of machined edges in any size - length and width.

+/- .001" flatness per foot not to exceed +/- .005" overall +/- .003" parallelism between top & bottom surfaces.

Cast Aluminum Physical Properties
• Magnesium - 0.4%
• Zinc - 7.5%
• Copper - 0.6%
• Aluminum balance

Brinell Hardness 74
Yield Strength 26,000 lbs
Tensile Strength 35,000 lbs

All "H" dimensions are nominal
Base sizes that are not listed can be made as required
Bases can be supplied to metric dimensions on request.
Aluminum Bases are machined on all sides.
Any other machining will be priced on application.

T = 1/2" minimum on 25" thru 44" lengths
T = 3/4" minimum on 45" thru 120" lengths